If a jeweler tells you a set of loose stones weighs a certain amount, you can ask them to show you that on a scale, just to be sure. This is what makes the points so important when differentiating stones based on weight. The weight of most loose diamonds is somewhere around that of a small paper clip. Assuming that it is one gem as mentioned in the example illustrated here, you can express it as one carat and 31.5 points diamond. You’re most likely to hear this trade and wholesaler term when purchasing jewelry especially engagement rings. Following that logic, a 100-pointer diamond refers to a 1 carat stone, 150-points means it’s a 1.5 carat stone, and so on. When a diamond weighs 0.5 carats, it’s a 50-point diamond. Once you have calculated both in your loose diamond, express its weight in both the terms. In short points are fractions of a carat. Express Diamond’s Weight In Terms of Points and Carats For instance, in case the weight is 1.315 carats, you have to divide the decimal points by hundred and the result is 31.5 points. Divide that figure by hundred, and the result will give you diamond’s points. Once you have converted the weight of the gemstone in carats, look at the digits following the decimal point of that carat weight figure. For instance, if the measurements scale shows 263 milligrams, then that equals 1.315 carats – which should be the same as what you noted down. In order to calculate the carats of the gemstone, divide its weight in milligrams by two hundred. In case the weight is displayed in grams, multiply that number by 1000, and then note down the resulting figure somewhere. You have to look at the display of the measurement scale. The gemstone should be loose while you place it on the scale – that is, if the diamond is set in a jewelry piece, it would need to be taken off first. To weigh the gem, it is best to use a sensitive scale, which is often recommended for measuring in milligrams. If you are curious to know the points and carats of loose diamonds you bought from somewhere, follow the below steps. In order to measure a loose diamond’s points and carats, you have to weigh the gemstone in milligrams or grams, and then convert that to the units you are interested in. In other words, one point equals two milligrams. While a one-carat diamond’s weight equals 200 milligrams, a point equals a hundredth of a carat. Points and carats are used to signify a diamonds’ weight.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |